Digi M10 Technical overview and Specifikace stáhnout pdf (Strana 10)

Digi m10 Hardware Reference v 1.20

Page 10 of 36

Figure 2: Digi m10 Pin Numbering

The connector provides the necessary interface signals to communicate over a 3.3V TTL level

serial link and to power Digi m10. Basic communication can be established using the Tx & Rx

lines and the remaining signals provide additional handshaking (RTS/CTS), status (SA/DA) and

debug information (D/jointfilesconvert/398620/bg_Tx/D/jointfilesconvert/398620/bg_Rx) as described in the following sections.

Refer to

Table 1 for details. The Digi m10 can be connected to the host PCB using a 14-pin

SAMTEC 1mm pitch, stacker header connector (MW-07-03-G-D-147-065-P).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Žádné komentáře

Digi M10 Technical overview and Specifikace Strana 10